Completely solid part

Discussions about firmware/slicing software, tweaks and settings
Post Reply
mcorb
Posts: 5
Joined: Thu Feb 06, 2014 12:27 am

Completely solid part

Post by mcorb »

Hi everyone,

can anyone please tell me how I need to set any slicing software to get a 100 % solid part all the way through? We are trying to print something with watertight channels inside and all the infilling is crating problems. i.e. seting infill solidity (ratio) to 1 instead of the initial 0.4 in SFACT does not solve the problem (and still creates infill rather than a solid part).

Thanks,
M

mcorb
Posts: 5
Joined: Thu Feb 06, 2014 12:27 am

Post by mcorb »

Think I found it after all. When you open up the config window in SFACT you still need to choose your print quality again. It is not automatically transfered from the previous window. Then all you need to do is what I described above.
M

Post Reply