I have just gotten an assembled Felix 3.0 dual extruder machine. I am playing around with some test printing and I am noticing throughout the prints the 2 small vertical fans never seem to go, is there a way to test these fans actually work, and at what point should they engage? I have setting cooling as an option in slicer, as i seem to be getting subpar quality on small bridges even though im going slow, and im figuring that would be a good time for the fans to kick in to help avoid that??
Any help appreciated.
When Should the 2 Small Vertical Fans go?
-
- Posts: 132
- Joined: Sat Jul 20, 2013 12:50 pm
- Location: Würzburg
The fans cooling the cold end?
They should run all the time!
They should run all the time!
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade