Can't Print a bridge

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
undergroundsurf
Posts: 16
Joined: Wed Jul 31, 2013 6:07 pm
Location: Switzerland

Re: Can't Print a bridge

Post by undergroundsurf »

I recommend you to use Slic3r. Slic3er has a bridge detection tool. It automatically slows down and goes straight accross a bridge. In my case it's slicing much better than Sfact.

Cheers

Saamec
Posts: 157
Joined: Fri Jun 21, 2013 9:28 am

Post by Saamec »

Nothing itself is not done automatically. All configurable speed slicer. What speed you specify with this and will be printed bridge. No Need to slicer instruct the intellect.

Post Reply