extruder stepper driver failure

Discussions about the electronics
Post Reply
stillcool40
Posts: 33
Joined: Sun Mar 30, 2014 1:59 pm

extruder stepper driver failure

Post by stillcool40 »

Seems the stepper driver has failed giving the "tick tick of death"

does anyone know if I can enable the stepper 0 and use that instead or switch on the dual head so I can select the 0 stepper.

(I fitted a new stepper already)

regards

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Sure it's broken? Isn't it a lose or broken wire? Or to much / to little power from the stepper driver (adjust the pod).

If you have a dual extruder, why not just switch connectors to make the other extruder the master?
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply