LCD unit

This is the place to show off your felix printer hacks and improvements.
Post Reply
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

Re: LCD unit

Post by Mayhem »

I got the graphics board but i cant find the thermistor settings that need to change for the felix hotend so can you point me where those are?
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Autodesk fusion 360

Posts: 15
Joined: Sat Nov 09, 2013 12:20 am
Location: U.K

Post by Kalidopixel »

I Thought i would share this , My Felix LCD Back light Failed after 13 Months & i Found a Perfect Low Cost Replacement Cost me just Under £6 & it has Brighter Backlight & Better Contrast to the Original Unit.

Its a Standard HD44780 (20X4) LCD Unit with Yellow / Green Backlight.

It has Automatic Contrast - Even the mounting holes are the same , Just Solder wires or add a header plug :)


Posts: 33
Joined: Sun Mar 30, 2014 1:59 pm

Post by stillcool40 »

has anyone actually fitted one of these displays to a felix ramps? if so some clear and detailed instructions for those of us who are NOT electronics wizards would be greatly appreciated.

Post Reply

Return to “Hacks and printer upgrades”