Attempting cold extrusion with no luck

Discussions about firmware/slicing software, tweaks and settings
Post Reply
structur3d
Posts: 4
Joined: Tue Apr 15, 2014 5:34 pm

Attempting cold extrusion with no luck

Post by structur3d »

Felix 3.0 with Dual Extruder 20140107 firmware installed.

I am attempting to cold extrude with no success. I am trying to test some NEMA motors using the extra motor controller on my felix. I have successfully updated the firmware and it is working fine for extruder #1 with heat, but I cannot get either Motor #1 or #2 to turn at room temperature. I have done this in the past using Marlin with no problem, just changing the temp sensor type to 0 (none). I have also tried the M302 command in Repatier.

I am not having much luck playing with the gcode and configuration.h and would appreciate any input. Cheers!

structur3d
Posts: 4
Joined: Tue Apr 15, 2014 5:34 pm

Post by structur3d »

Found the min extrude temp and changed to 0.
Is there a way to define this based on specific extruders?

Post Reply