Faced with the following problem. Flooded new firmware Repetier and now if the printer is not used in the sense I don't give him any commands, then he turns off the power. Does any timer. This leads to the fact that printing stops after a power outage. Don't know where to fix it in the firmware?
Thanks for the answers)) there were many of Them and all of the case the problem is solved by setting the EEPROM:
Printer active [s] = 0
Max. inactive time [ms,0=off = 0
Stop stepper after inactivity [ms,0=off = 0
Thanks, that helped... I had to understand everything yourself... use.