Optimal acceleration settings to reduce ringing?

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
andrewsi
Posts: 130
Joined: Mon Dec 23, 2013 1:26 am

Optimal acceleration settings to reduce ringing?

Post by andrewsi »

Just curious if anyone has experimented with changing x/y accel or XYJERK settings in firmware to reduce "ringing". Ringing is the slight waviness you see on the wall of a print after the head has gone around a sharp corner, which then fades down as the head continues to travel, until the next sharp corner at which point it begins again.

Haven't done much experimentation yet myself, but I definitely get quite a bit of ringing artifacts on squarish objects at the default acceleration settings.
__________________________________________
Andy Silverman, Technogeek in Seattle
Felix Tec4 Single-head

Post Reply