Anyone printing with Ninjaflex?

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
Eli-Audio
Posts: 30
Joined: Wed Dec 17, 2014 10:23 pm

Re: Anyone printing with Ninjaflex?

Post by Eli-Audio »

Just ordered a E3D extruder...

gillespinault
Posts: 10
Joined: Sun Mar 16, 2014 9:50 am

Post by gillespinault »

Alternatively, you can try my modified extruder arm inspired by the Lulzbot Flexystruder. I had great success with filaflex since I installed it:
http://forum.felixprinters.com/viewtopic.php?f=9&t=1133

Eli-Audio
Posts: 30
Joined: Wed Dec 17, 2014 10:23 pm

Post by Eli-Audio »

gillespinault wrote:Alternatively, you can try my modified extruder arm inspired by the Lulzbot Flexystruder. I had great success with filaflex since I installed it:
http://forum.felixprinters.com/viewtopic.php?f=9&t=1133
I did print the part, just need to put it in. How does the tube stay in his place when retracting or removing filament?

fesch
Posts: 35
Joined: Fri Dec 05, 2014 11:14 pm
Location: Luxembourg
Contact:

Post by fesch »

I would appreciate a picture of an installed extruder arm ...

Post Reply