mounting Z-axle rail - step 15

Help eachother out with assembly problems.
Post Reply
Pieter
Posts: 8
Joined: Thu Jun 05, 2014 7:01 pm

mounting Z-axle rail - step 15

Post by Pieter »

just started mounting my 3.0
step 15 of the manual says "10mm between plastic and rail", is this right???
In the drawing the rail seems to touch the plastic of the motor bracket.

Dreide
Posts: 176
Joined: Sun Sep 29, 2013 12:32 am
Location: Lausanne, Switzerland

Post by Dreide »

Have a closer look. You can still see a bit of the channel of the aluminum profile between the plastic and the rail.
Felix 2.0->3.0dual * Repetier (host+firmware) * KISSlicer Pro, Simplify3D * Cubify Design

Pieter
Posts: 8
Joined: Thu Jun 05, 2014 7:01 pm

Post by Pieter »

ok thx!
It's a bit confusing with the reflections. (& in step 28 there seems to be no space left)

Dreide
Posts: 176
Joined: Sun Sep 29, 2013 12:32 am
Location: Lausanne, Switzerland

Post by Dreide »

True. You just have to check that the cart cannot run off the rail when the print bed is between Z=0 and Z=max. Having no gap can turn out a bit tight at the Z=0 end, but you still can adjust this later on, I guess.
Felix 2.0->3.0dual * Repetier (host+firmware) * KISSlicer Pro, Simplify3D * Cubify Design

Pieter
Posts: 8
Joined: Thu Jun 05, 2014 7:01 pm

Post by Pieter »

ok thank you!

Post Reply