Note: compared to the photo I have made one adjustment: Increased height with 2mm to hide all washers.
Fun observation: you can easily see the washers through the plastic
Crinkled washer sleeve
Crinkled washer sleeve
I made a quick and dirty sleeve for the crinkled washers beneath the hot bed.
It's a quick print, looks much neater and should keep the washers in place (not that i have had any problems with it).
Note: compared to the photo I have made one adjustment: Increased height with 2mm to hide all washers.
Fun observation: you can easily see the washers through the plastic
It's a quick print, looks much neater and should keep the washers in place (not that i have had any problems with it).
Note: compared to the photo I have made one adjustment: Increased height with 2mm to hide all washers.
Fun observation: you can easily see the washers through the plastic
- Attachments
-
- crinkled_washers_sleeve.stl
- (418.61 KiB) Downloaded 61 times
Wont the plastic get soft if you heat the bed above 70 degrees this way? The layered washers also act as a heatsink to dissipate the heat from the heated bed.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
I haven't experienced any problems (yet). Had the bed at 60 degrees for 1-1.5 hours. Your milage may wary though...