Hey there
When i press the z button to -10 mm in repetier the printer descents almost 17 mm
Having the same problem when i press the the 1 and 0,1
Any idea on how to fix this
The step are just to big
Z axis steps to big
-
- Posts: 84
- Joined: Sun Apr 20, 2014 6:23 pm
You can set the steps/mm - value for the different axes at the eeprom-settings.
Repetier-Host -> configuration -> Firmware EEPROM configuration.
You should decrease the ammount of steps per mm until it fits.
Repetier-Host -> configuration -> Firmware EEPROM configuration.
You should decrease the ammount of steps per mm until it fits.