Empty display

Discussions about the electronics
Post Reply
Deluka
Posts: 23
Joined: Sat May 03, 2014 5:05 am

Empty display

Post by Deluka »

Just finishing up (felix 3 dual ex) and i notice there are only blocks on my display
I check if the connections were good and found no problem
Not sure it was a hardware or firmware problem.
I loaded the marlin version
I already noticed that the steps on the z axis where way of.
Correct this more or less in the eeprom settings

Anybody any ideas?

Deluka
Posts: 23
Joined: Sat May 03, 2014 5:05 am

Post by Deluka »

Found out what was wrong
I loaded the wrong firmware
The display is working and my z problem seems to be solfed

Post Reply